Services and labour times
Every job here is a from price: the labour time we book, times the shop rate, plus the cheapest parts we would put on your car. We confirm the real number after we see it.
- Shop rate
- $125.00 per hour
- Shop supplies
- 5 % of labour, $35 max
- Tax
- HST 13 % on the total
Brakes
We measure before we quote: pad lining in mm, rotor thickness against the minimum stamped on the hat, runout with a dial indicator.
Some of this is in the High-mileage plan| Job and what we do | Included | Not included | Labour | From | Book |
|---|---|---|---|---|---|
| Front pads and rotors, per axleNew pads, rotors and abutment clips. Clean and grease slide pins, torque to spec, bed-in road test. | Pads, rotors, clips, grease, road test | Calipers, brake fluid flush | 1.60 h | $420.00 | Book Front pads and rotors, per axle |
| Rear pads and rotors, per axleAs front. Electronic park brakes are put in service mode with the scan tool first. | Pads, rotors, clips, park brake reset | Park brake shoes, calipers | 1.80 h | $440.00 | Book Rear pads and rotors, per axle |
| Front pads only, per axleOnly when the rotors measure above minimum and run true. If they don't, we call you first. | Pads, clips, slide pin service | Rotors, machining | 1.00 h | $220.00 | Book Front pads only, per axle |
| Brake fluid flushPressure bleed all four corners with new DOT 3 or DOT 4 until it runs clean. Moisture tested before and after. | Up to 1 L fluid, moisture test | ABS module bleed procedures | 0.80 h | $125.00 | Book Brake fluid flush |
| Caliper replacement, eachRemanufactured caliper, new copper washers on the hose, bleed that circuit. | Caliper, washers, bleed | Pads, hoses | 1.00 h | $265.00 | Book Caliper replacement, each |
Suspension and steering
Windsor roads and road salt are hard on links and bolts. On older cars we book extra time for seized hardware and tell you up front.
| Job and what we do | Included | Not included | Labour | From | Book |
|---|---|---|---|---|---|
| Front sway bar links, pairReplace both links. Most clunks over bumps on Drouillard start here. | Two links, new nuts | Bushings, alignment | 0.80 h | $170.00 | Book Front sway bar links, pair |
| Front struts, complete assemblies, pairLoaded strut assemblies with new mounts and springs. Alignment needed after. | Two strut assemblies | Alignment | 2.40 h | $690.00 | Book Front struts, complete assemblies, pair |
| Outer tie rod ends, pairReplace both ends, count the turns, set toe close for the drive to the rack. | Two tie rod ends | Alignment | 1.20 h | $240.00 | Book Outer tie rod ends, pair |
| Front lower control arm, eachArm with bushings and ball joint. Bolts torqued at ride height. | Control arm, hardware | Alignment | 1.20 h | $300.00 | Book Front lower control arm, each |
| Four-wheel alignmentCamera aligner on the four-post rack. You get the before and after printout. | Toe, camber, caster where adjustable | Seized adjusters, ADAS camera calibration | 1.00 h | $125.00 | Book Four-wheel alignment |
Diagnostics and electrical
A code is a starting point, not a part number. The diagnostic fee buys a technician's time to find the cause, not a printout.
| Job and what we do | Included | Not included | Labour | From | Book |
|---|---|---|---|---|---|
| Check engine light, diagnostic scanScan, freeze frame data, first round of tests. You get the cause or the next step, in writing. | Up to 0.75 h of testing | Repairs, further testing past 0.75 h | 0.75 hflat rate | $95.00 | Book Check engine light, diagnostic scan |
| Electrical fault tracing, per hourWiring diagrams, meter and scope work on a fault that comes and goes. | One hour of tracing | Parts, harness repair beyond 1 h | 1.00 h | $125.00 | Book Electrical fault tracing, per hour |
| Battery test and replacementLoad test battery and charging system. Replace with a matching group size, register it where the car needs it. | Battery, test, registration | Alternator or starter work | 0.40 h | $235.00 | Book Battery test and replacement |
Oil and fluids
We use the oil spec in your owner's manual, not whatever is in the bulk tank. The spec goes on the invoice.
Some of this is in the Oil plan| Job and what we do | Included | Not included | Labour | From | Book |
|---|---|---|---|---|---|
| Oil service, full syntheticDrain, new filter, refill to spec. Check fluids, tire pressures, lights and wipers while it is up. | Up to 5 L synthetic, filter, top-ups | Extra litres ($9/L), cartridge filters | 0.40 h | $89.00 | Book Oil service, full synthetic |
| Coolant drain and fillDrain, refill with the coolant type the maker calls for, bleed air, pressure test the system. | Up to 6 L coolant, pressure test | Hoses, thermostat, water pump | 0.80 h | $145.00 | Book Coolant drain and fill |
| Transmission fluid drain and fillDrain and fill with the correct fluid, check level at temperature the way the maker says. | Up to 5 L fluid | Filter or pan gasket where fitted | 1.00 h | $215.00 | Book Transmission fluid drain and fill |
Tires and seasonal changeover
Winter tires on by mid-November is a good rule here. Book early: the last two weeks before the first snow fill up.
Some of this is in the Maintenance plan| Job and what we do | Included | Not included | Labour | From | Book |
|---|---|---|---|---|---|
| Seasonal changeover, on rimsSwap four wheels, set pressures, torque by hand with a calibrated wrench. Re-torque check free after 100 km. | Four wheels, pressures, torque | Balancing, TPMS sensors | 0.50 hflat rate | $60.00 | Book Seasonal changeover, on rims |
| Seasonal changeover, mount and balanceTires off one set of rims and onto the other, new valve stems, balance all four. | Mount, balance, valve stems | TPMS sensors, disposal | 1.00 h | $145.00 | Book Seasonal changeover, mount and balance |
| TPMS sensor, eachNew sensor, programmed and relearned to the car. | Sensor, relearn | Mounting, if the tire is on a rim | 0.40 h | $110.00 | Book TPMS sensor, each |
| Tire storage, one season, set of fourBagged, tagged with your plate, stored indoors off the floor until next season. | Storage until next changeover | Changeover itself | n/aflat rate | $80.00 | Book Tire storage, one season, set of four |
Inspections
Buying used? Bring it here before you pay. We write down what we find with measurements, and we have nothing to sell you on that car.
Some of this is in the Maintenance plan| Job and what we do | Included | Not included | Labour | From | Book |
|---|---|---|---|---|---|
| Pre-purchase inspectionRoad test, scan, on the lift top to bottom: brakes, steering, leaks, rust, tires. Written report with photos. | Report, scan, road test | Repairs, compression tests | 1.40 h | $175.00 | Book Pre-purchase inspection |
| Annual inspection, written reportOnce over on the lift: brakes measured, tires, steering and suspension, leaks, belts, battery test, fluids. You get the numbers in writing. | Measurements, battery test, report | Repairs, fluids beyond top-ups | 0.60 h | $75.00 | Book Annual inspection, written report |
| Ontario safety standards certificateFull inspection to the provincial standard. If it fails we list what is needed and quote it. | Inspection, certificate if it passes | Repairs needed to pass | 1.00 hflat rate | $120.00 | Book Ontario safety standards certificate |
Front brake, wheel off
Seven parts stop the car. Here is what wears on each one, how it shows up when you drive, and what we measure before we quote a brake job.

| Number | Part | What fails | What we check | Spec |
|---|---|---|---|---|
| 1 | Wheel studs | Stretched or cross-threaded by an impact gun run too hard. A stretched stud can snap. | Threads and straightness. Wheel nuts go on by hand and get torqued with a calibrated wrench. | Torque per the maker |
| 2 | Hub and bearing | Bearing wear: a hum that rises with speed and changes when you turn. Play at the wheel. | Rock the wheel at 12 and 6 o'clock, spin it and listen. Flange runout with a dial indicator. | Runout per the maker |
| 3 | Caliper bracketNot in the photo | Rust builds up under the pad clips and pinches the pads, so they drag and wear unevenly. | Abutments cleaned to bare metal. Bracket bolts torqued to the maker's figure, threadlocker where called for. | Torque per the maker |
| 4 | Brake pads, inner and outerNot in the photo | Lining wears down to the backing plate. An inner pad worn far more than the outer means a sticking slide. | Lining measured in mm on both pads, both sides. Taper wear, cracks, lining lifting off the plate. | We replace at 3 mm |
| 5 | Rotor | Worn below minimum thickness, or runout that you feel as a pulsing pedal. Heavy rust on the vanes. | Micrometer at eight points against the minimum stamped on the rotor. Runout with a dial indicator. | Min. thickness as stamped |
| 6 | Caliper | Seized piston or torn dust boot. The car pulls to one side and one wheel runs hot. | Piston pushes back smoothly, boot intact, no fluid weep. Brake fluid moisture tested. | Fluid tested every visit |
| 7 | Hardware: pins, clips, boltsNot in the photo | Dry or seized guide pins, missing clips. That gives you squeal, drag and uneven pad wear. | Pins slide freely on high-temperature grease, boots sealed. New clips with every pad job. | New clips every pad job |
From means from
Parts prices move and every car is different. The figure here is the floor. Your written estimate is the real number, and you see it before we start.
Labour is book time
We use published labour times, not a stopwatch. If a seized bolt adds an hour, we call you before that hour gets spent.
Your parts, your call
You can bring your own parts. We fit them at labour only, and the part carries its own warranty, not ours.